page 2
Construction Manual- The manual contains over 100 pages of instructions , photos and drawings detailing the construction of the Kingfisher electric kayak. It is a 3 ring binder permitting the removal of the drawings and text during construction. Most drawings are full size and all have sufficient detail to allow you to construct the parts without the need for precise measurements. You will find the Maintenance and Operation sections very helpful in keeping you boat in top condition, ready for fun on the water.
KF-10 Construction Manual P/N 01-1145 $ 60.00
KF-12 Construction Manual P/N 01-1146 $60.00
Construction Manual- The manual contains over 100 pages of instructions , photos and drawings detailing the construction of the Kingfisher electric kayak. It is a 3 ring binder permitting the removal of the drawings and text during construction. Most drawings are full size and all have sufficient detail to allow you to construct the parts without the need for precise measurements. You will find the Maintenance and Operation sections very helpful in keeping you boat in top condition, ready for fun on the water.
KF-10 Construction Manual P/N 01-1145 $ 60.00
KF-12 Construction Manual P/N 01-1146 $60.00
Modified M-K Endura Motor
This motor is new and modified for use on a K-F boat. The standard prop is a 2 blade unit The propeller in the photo is an optional 3 blade part that must be ordered separately. The remote tilt up modification is included and permits the paddler to lift or lower the motor from the seat. The motor transom bracket permanently mounts with 4 screws to the transom and rear deck. The motor can be removed or installed in the bracket without tools for easy transport of the boat. The motor also includes the tiller bracket to which the steering cables are attached. The M-K manual tilt feature is still functional. The power wires connect to two terminal studs in the transom.
KF10 or KF12 Modified Motor P/N 01-1041 $ 325.00
Optional Prop 3 blades P/N 01-1036 $45.00
KF10 or KF12 Modified Motor P/N 01-1041 $ 325.00
Optional Prop 3 blades P/N 01-1036 $45.00
Motor Controller
The motor controller in the photo is located on the left (port) side of the boat under the deck. This is a relatively dry location with adequate air circulation to cool the unit. The 10 gauge battery and motor wires connect to the screw down terminals on the rear of the unit. The connector on the front provides the electrical inputs from the Pedal Sensors and the speed control in the Control Panel. The voltage to the motor is varied from 0 to 12 volts when the speed control is moved from its aft position to its forward position. This type of control circuit offers 2-4 times the run time of the factory 5 speed selector for a single battery charge. Selecting reverse causes the controller to reverse the power polarity to the motor. The current to the motor is internally limited to 40 amps. There are no options or adjustments in this unit.
KF10-12 Motor Controller P/N 01-2002 $320.00
The motor controller in the photo is located on the left (port) side of the boat under the deck. This is a relatively dry location with adequate air circulation to cool the unit. The 10 gauge battery and motor wires connect to the screw down terminals on the rear of the unit. The connector on the front provides the electrical inputs from the Pedal Sensors and the speed control in the Control Panel. The voltage to the motor is varied from 0 to 12 volts when the speed control is moved from its aft position to its forward position. This type of control circuit offers 2-4 times the run time of the factory 5 speed selector for a single battery charge. Selecting reverse causes the controller to reverse the power polarity to the motor. The current to the motor is internally limited to 40 amps. There are no options or adjustments in this unit.
KF10-12 Motor Controller P/N 01-2002 $320.00
